Product guide

18 System Description
19MAXDATA PLATINUM 90004R Server System
A
B
C
D
F
G
H
I
OM12886
E
Figure 3. Front Panel Controls and Indicators
Table 3. Front Panel Control and Indicator Description
Item Feature Description
Switches
A. System ID Switch Toggle switch for blue System ID LEDs (the front panel system ID LED
is located inside the system ID switch). See E below for description of
LED operation.
B. Assert SDINT
(System Diagnostic
Interrupt) Switch
Asserts SDINT. This switch is accessible through a small opening and
requires a narrow tool to activate.
C. Reset switch Resets the system.
D. Power switch Toggles system power. A delay of ~5 seconds is required between
pressing the power switch to power down and then power up the
system.
LED Indicators
E. System ID (Blinking
or Solid Blue). The
system ID LEDs are
located inside the
system ID switch on
the front panel and
on the back panel
Identifies the system. The system ID is activated either by the system
ID switch or through server management software.
Pressing the system ID switch once turns on the LEDs solid blue.
Press the system ID switch again, the solid blue LEDs turn off.
Remove activation - LEDs turn on blinking for 4 minutes (max). The
system ID LEDs cannot be turned off by pressing the switch.
F. Main Power (Solid
or Blinking Green)
A continuously lit LED indicates the presence of DC power in the
system. The LED goes out when the power is turned off or the power
source is disrupted. Blinking Green indicates the system is in sleep
mode.
G. Power Fault (Solid
Amber)
Indicates any system power faults. Off indicates power is OK.
H. Cooling Fault (Solid
Amber)
Indicates any system cooling faults. Off indicates system
cooling is OK.
I. General Fault (Solid
amber)
Indicates a system failure. Off indicates system is OK.