Product guide
148 Warnings
149MAXDATA PLATINUM 90004R Server System
Warning: English (continued)
For proper cooling and airflow, unless hot swapping PCI cards or fans, always
reinstall the chassis covers before turning on the system. Operating the system
without the covers in place can damage system parts. To install the covers:
1. Check first to make sure you have not left loose tools or parts inside the
system.
2. Check that cables, add-in boards, and other components are properly
installed.
3. To replace the top back cover, slide the two bearing cages on the back top
cover all the way to the end of the slides.
4. Place the top cover on the cover slides and push the cover into place.
5. To replace the top front cover, attach the back edge of the front top cover to
the chassis, lower the front edge of the cover onto the chassis, then push the
cover into place.
6. Tighten the two captive screws on either side of the cover.
7. Connect all external cables and the AC power cord(s) to the system.
A microprocessor and heat sink might be hot if the system has been running.
Also, there might be sharp pins and edges on some board and chassis parts.
Contact should be made with care. Consider wearing protective gloves.
Danger of explosion if the battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by the equipment manufacturer. Discard
used batteries according to manufacturer’s instructions.
The system is designed to operate in a typical office environment. Choose a site
that is:
• Clean and free of airborne particles (other than normal room dust).
• Well-ventilated and away from sources of heat including direct sunlight.
• Away from sources of vibration or physical shock.
• Isolated from strong electromagnetic fields produced by electrical devices.
• Protected when in regions that are susceptible to electrical storms. We
recommend you plug your system into a surge suppresser and disconnect
telecommunication lines to your modem during an electrical storm.
• Provided with a properly grounded wall outlet.
• Provided with sufficient space to access the power supply cords, because
they serve as the product’s main power disconnect.
Servers can be too heavy for a single person to lift or move safely. Depending
on the server, use two people or a mechanical assist to lift or move the server.