Operation Manual

Troubleshooting
Problems and Possible Solutions 8 - 11
8
The PC Camera module cannot be
detected.
The module is off. Press the Fn + F10 key combination in order to enable the
module (see “Function/Hot Key Indicators” on page 1 - 10). Run the
BisonCap program to view the camera picture.
The Wireless LAN/Bluetooth/ PC
Camera/3.75G/HSPA modules cannot be
configured.
The driver(s) for the module(s) have not been installed. Make sure you have
installed the driver for the appropriate module (see the instructions for the
appropriate module in “Modules & Options” on page 7 - 1).
A file cannot be copied to/from a
connected Bluetooth device.
The transfer of data between the computer and a Bluetooth enabled device is
supported in one direction only (simultaneous data transfer is not
supported). If you are copying a file from your computer to a Bluetooth enabled
device, you will not be able to copy a file from the Bluetooth enabled device to
your computer until the file transfer process from the computer has been
completed
The Bluetooth module is off after
resuming from Sleep.
The Bluetooth module’s default state will be off after resuming from the Sleep
power-saving state. Use the key combination (Fn + F12) to power on the
Bluetooth module after the computer resumes from Sleep.
The computer is off (or in Sleep Mode) but
powered by the AC/DC adapter plugged in
to a working outlet, or by battery with a
capacity above 20%. I have plugged a
device into the powered USB port in
order to charge it, but the device is not
charging.
The port is not powered on. Toggle power to the port using the Fn + power
button combination.
This function may not work with certain external USB compliant devices (check
your device’s documentation). If this is the case, power the computer on and
connect the external USB device in order to charge it.
Problem Possible Cause - Solution