User manual

14 - Belinea 10 17 10
ENGLISH
Blank Screen
Power indicator is off
- Make sure the power cable and the power adapter are connected properly (see section “Connecting”).
- Make sure that the monitor was turned on using the power switch (see section “Startup”).
Power indicator lights green
- A screen saver may have activated automatically after a certain period of inactivity. Press any key on your keyboard
or move the mouse.
Power indicator lights orange
- Could a power saving mode be active? Press any key on your keyboard, or move the mouse.
“No Signal” message
- Is the signal cable connected to the monitor and the PC’s graphics port (see section “Connecting”)?
- Is the PC turned on (see your PC’s documentation)?
TROUBLESHOOTING
TECHNICAL SPECIFICATIONS
LCD panel 17 inch diagonal size (43.2 cm visible), low radiation according to TCO ’99, certifi ed
to ISO 13406-2, pixel fault class II, TN panel technology
Contrast ratio 500:1 (typical)
Viewing angle horizontal 150°, vertical 135° (typical)
Response time Rise time: 3 ms, Fall time: 10 ms (typical)
Brightness 300 cd/m
2
(typical)
Input signal Video: analog (D-SUB)
Display colors 16.2 mill. colors (FRC)
Synchronization 31–80 kHz horizontal, 56–75 Hz vertical
Video band width 135 MHz (pixel rate)
Ergonomic resolution 1280 × 1024 (60 Hz)
Audio Amplifi er: 2 × 2 W at 8 Ohms
Loudspeaker: 1 W continuous load, 2 W peak power
Power connection Input: 100–240 V AC, 50–60 Hz, 1.0 A
Power consumption ON status: max. 45 W; color of the status LED: green
SLEEP status: < 1 W; color of the status LED: orange
Power saving functions EPA certifi ed
Dimensions / weight Width: 372.5 mm, height: 395.5 mm, depth: 185 mm; 3.8 kg (net)
Operating environment Operation: 0 to +35 °C, humidity: 30–80 % (without condensation)
Storage: -5 to +45 °C, humidity: 5–90 % (without condensation)
Display Problems
Image is displaced to the left/right or to the top/bottom
- If the image appears normal but off-center, you can adjust it using the OSD functions. For further information, see
chapter “Basic Setup”, section “Auto Image Adjustment”.
Image flickers or is shaky
- Perhaps setup fi le chosen for the monitor is incorrect. For information on monitor setup under Windows
®
9x/ME/
2000/NT/XP consult the “Confi guration” section.
Image is blurred
- Check brightness and contrast settings (see chapter “OSD Menu Functions”, sections “Brightness” and “Con-
trast”).
Color problems
- If the colors are off (e.g. white is not really displayed as white, etc.), you should adjust the color temperature (see
“Color Control” function in section “OSD Menu Functions”).