Service manual

Disassembly and Reassembly
11
111707 Service Manual
DISASSEMBLY AND REASSEMBLY
3. Disassembly and Reassembly
The section of the service manual describes the disassembly and reassembly procedure for
the Belinea 101725 Monitor.
WARNING : This has to be disassembled and reassembled carefully because TFT-LCD Panel
is weak for impact. This monitor contains electrostatically sensitive devices.
Use caution when handling these components.
3-1 Disassembly
Cautions : 1. Disconnected the monitor from the power source before disassembly.
2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.
3-1-1 Separation between display part and stand part
1. Diconnect Power Cord and Signal Cable.
2. Remove the 4 screws on the stand.
3. Pry it off the back stand of the monitor.
3-1-2 The Display part Disassembly
The Rear housing Removal
1. Remove the 2 screws on the rear corner of the Rear Cover.
2. Remove Rear Cover from the Front Cover.
3. Remove 2 screws on the Rear Shield Cover and remove it.
4. Disconnect Combo harness and LVDS harness.
5. Remove 4 screws on the Main PCB.
6. Remove 1 screws on the F.G cable of Combo Board.
7. Remove 4 screws on the Combo Board Assembly and then remove it.
8. Remove I/O Shield.
9. Disconnect Key harness on the Main Board.
10. Remove the LVDS harness on the Panel.
11. Remove 2 screws on the Main chassis.
12. Remove Front Cover.
13. Remove 4 screws on the Side of Panel.
14. Remove the Main chassis.