User manual

Page 6 of 10
Menu # 3 - UNIT TEMP
Read-only menu, indicates the system temperature
Menu # 4 - RF LVL
Read-only menu, indicates the RF input level
Menu # 5 - RF MODE
Current RF mode, display AGC/Manual
If it appears RF Mode = AGC, while it was in the state of AGC
If it appears RF Mode = Manual, while it was in the state of MGC
Menu # 6 - +5V Reads
Read-only menu, display the voltage +5V
Menu # 7 - -5V Reads
Read-only menu, display the voltage -5V
Menu # 8 - +24V Reads
Read-only menu, display the voltage +24V
Menu # 9 - IP
Adjustable list, display the IP address of SNMP (optional)
Menu # 10 - Subnet
Adjustable list, display the address of net mask (optional)
3.1.3 Menu assistant manual
Press STATUS key for 1 or 2 seconds to amend the address menu that you
wish to change, press STATUS for 1 or 2 seconds to choose the amend
location, push STATUS currently value +1, press STATUS to the end of the
address to enter into save and exit.
For example, amend IP setup menu, IP: 192.168.000.015; if changing 5 to
6, use STATUS key to choose the place of 5, then press STATUS key to
change 5 to 6, then press STATUS to save amended IP: 192.168.000.016
The default control mode is AGC. When the OMI modulation menu displays
RF Mode=AGC, press "▲" key and the menu will display RF Mode=AGC (AGC
flicker). Then press "▼", the menu will display RF Mode=Manual and the
change from AGC to MGC has been completed. If you want to change the
current control mode back into AGC, press "▲" key when the current menu
displays RF Mode=Manual, then the menu will display RF Mode=AGC (AGC
flicker). Then press "▼", the change from Manual to AGC will be complete
and the menu will display RF Mode=AGC.