User's Manual

77
RIOTRONIC X+
User Manual
In Step 2 mode should be set to DHCP or STATIC. In case of static, IP address, gateway and
mask must be set. Then Setting button should be pressed to confirm and Next Step to go to
Step 3.
Figure 102. WiFi configuration - Step 2
In Step 3 all accessible networks are listed. Button Join button have to be pressed next to
preferred network name. User may be asked for password then. After confirming, modem is
restarted with new configuration. Web browser may be closed.
Figure 103. WiFi configuration - Step 3
8.7. PC connection
Remote can be connected to PC with USB cable. Its internal memory can be accessed as mass
storage device then.
Remote should be turned on after USB cable is connected to PC. Mass storage mode will be
started.
If Remote was already turned on before it also starts Mass storage mode.
Figure 104. Mass storage mode screen
Before disconnecting USB cable it is important to dismount drive in PC operation system.
When USB cable is disconnected Remote automatically is turned off.