User's Manual

41
RIOTRONIC X+
User Manual
6.5.5.8. Auto off timer
Auto off timer can be set with the value between 1 and 60 minutes. If no key is pressed within
this time Logger will be automatically turned off. Value 0 means auto off timer function is
disabled.
6.5.5.9. Buttons beep
If this function is on, there is a beep signal with every key pressed. If this is off, beep signal
is only for important notifications.
6.6. PC connection
Logger can be connected to PC with USB cable. Its internal memory can be accessed as mass
storage device then.
Logger should be turned on after USB cable is connected to PC. Mass storage mode will be
started. If Logger was already turned on before it also starts Mass storage mode.
Figure 36. Mass storage mode screen
Before disconnecting USB cable, it is important to dismount drive in PC operation system.
When USB cable is disconnected Logger automatically is turned off.
6.7. Battery charging
Current battery level is displayed on top bar of display.
To charge the battery dedicated power supply has to be connected to CHARGE socket at the
bottom of Logger. Logger automatically starts charging and suitable message will be
displayed. There is no possibility to use Logger while charging.
Figure 37. Battery charging screen