User's Manual

40
RIOTRONIC X+
User Manual
Figure 36. System submenu
6.5.5.1. System info
Displays Logger’s serial number, firmware version, date of last battery changes and revision.
6.5.5.2. Clean memory
It is to delete all patterns from Logger’s memory.
6.5.5.3. PIN settings
It is to change user or admin PIN. To change admin PIN, it must be entered when the device
is starting.
PIN can be from 1 to 8 digits long or empty. If user PIN is empty, Logger will not ask for PIN
on start.
Admin PIN can be entered as old PIN, when user PIN is changed.
6.5.5.4. Time and date
Current time and date can be set there.
6.5.5.5. Device ID
Each logger is defined by ID. ID is a letter from A to F. Logger’s ID is stored in detonators
while programming. It can be helpful when many Loggers are used in the same time on
blasting site.
6.5.5.6. Language
Language can be changed there.
6.5.5.7. Brightness
Display brightness can be changed. The value can be set by left and right arrow key or
entered with numeric keys. OK or F2 key have to be pressed to store the value.