User's Manual

35
RIOTRONIC X+
User Manual
In manual programming mode there are two information on the screen: detonator’s number
and delay time. User can switch between them using up and down arrows. Delay time can be
entered using numeric keys. Detonator’s number can be entered with numeric keys or
changed with left and right arrows. When Delay time is entered for specific detonator, OK or
F2 button have to be pressed to program connected detonator.
6.3.2. Incremental mode
Figure 32. Incremental programming screen
In incremental programming mode there are three information on the screen: detonator’s
number, delay time and delay increment. User can switch between them using up and down
arrows. Increment can be changed used left and right arrows. Once user left the increment
field, it disappears, and screen looks like in manual mode. When Delay time is set, OK or F2
button have to be pressed to program the connected detonator. When the detonator is
programmed, time increment field is back for next detonator.
The number and value of increments can be set in settings menu.
6.3.3. No delay mode
Figure 33. No delay programming screen
In no delay programming mode there is only detonator’s number on the screen. and delay
time. User can only press OK or F2 button to “program” connected detonator. In this mode
only detonator’s ID is read and stored with pattern. Delay time can be set later for whole
pattern and massive programming can be performed.
6.3.4. PC mode
In PC programming mode there are two information on the screen: detonator’s number and
delay time. This mode is similar to manual mode, but the delay time for each detonator is
Detonator’s number in pattern with logger’s ID letter
Delay time
Delay time increment
Detonator’s number in pattern with logger’s ID letter