User's Manual
37
RIOTRONIC X+
User Manual
reprogrammed) is displayed. If there are any missing or error detonators, detailed
information can be displayed using up and down arrows and OK or F2 keys.
If there are no errors BACK and F2 buttons leads to main menu. In other case BACK key
starts another test.
6.4.3. Test pattern
Test pattern is to test connection with detonators in the active pattern. Bus-line should be
connected to the Logger before initiating this test. In this test each detonator in the range is
checked if it is connected and programmed for correct delay time. If programmed delay time
is different from pattern, detonator is reprogrammed. At the end, Logger is checking if there
are any extra detonators connected to the Bus-line.
As the result, quantity of OK (including reprogrammed) detonators, missing (not connected
to the bus-line) detonators, error detonators (with wrong time, which cannot be
reprogrammed) and extra detonators is displayed. If there are any missing, error or extra
detonators, detailed information can be displayed using up and down arrows and OK or F2
keys.
If there are no errors BACK and F2 buttons leads to main menu. In other case BACK key
starts another test.
6.4.4. Test leakage
Test leakage is to measure the current consumed by bus-line with detonators. The result is
displayed in mA.
6.4.5. Test resistance
Test resistance is to measure the resistance between line terminals. The result is displayed
in kΩ.
6.4.6. List dets
List dets is to list all detonators in active pattern. To navigate in the list up, down, left and
right arrow keys can be used. F2 key allows to check detailed information about each
detonator. The detonator can be edited or deleted then.
6.4.7. Transfer data
Transfer data is to send or receive patterns to and from Blaster or another Logger.