User's Manual

67
RIOTRONIC X+
User Manual
8.2.5. Communication antenna socket
Remote is equipped with remote communication modem. Depending on version it could be
WiFi modem or RF modem (868 MHz or 915 MHz). Socket for remote communication antenna
is placed on the top of Remote.
Appropriate antenna should be connected before remote communication is started.
Figure 81. Communication antenna socket
8.2.6. NFC antenna
Remote is equipped with NFC communication antenna. NFC is used to read RFID card for
blast authorisation. NFC antenna is placed at the back of Remote’s case. It’s exact position is
marked by the white rectangle.
Figure 82. NFC antenna
8.3. Turning device on and off
To turn the device on press ON/OFF button and hold for about 3 seconds. Remote proceed
with initial auto test. If PIN checking is enabled, enter PIN and press OK or F2 button.
Remote starts with Blasters connection screen pair the devices.
To turn the device off press ON/OFF button and then confirm with OK or F2 button. If
ON/OFF button is pressed and held for longer than 3 second, Blaster will be turned off
without confirmation screen.