Operation Manual

SFX SERIES USER’S GUIDE
Rev 2.2 48
Column Description
Figure 2- 4)). The words “Edit Table” appear if the route can be edited from the Edit Static
Routing Table page.
Destination For locally configured routes, this field corresponds to the Destination entered in the Edit Static
Routing Table page (Figure 2- 23). For routes established elsewhere (e.g. Identity Edit page),
the destination is the subnet derived from the IP Address and Netmask of the associated
network interface.
Aside from the Common Menu Items, the following menu items are available:
Menu Item Description
Show Table Selecting this button will always return you back to the Static Routing page, as shown in Figure
2- 22.
Edit Table Selecting this button will enter the Edit Static Routing Table page, as shown in Figure 2- 23.
Figure 2- 23 Edit Static Routing Table Page
The following fields can be edited on the Edit Static Routing Table page:
Edit Field Description
Interface This drop down box selects the network interface that is applicable to the route. In most typical
routing configurations, you want this to remain on AutoSelect, which routes packets to the
interface that is on the same subnet as the Gateway.
Gateway A valid gateway address in dotted IP address notation is entered here, according to the rules
above. An address of 0.0.0.0 implies that there is no gateway. In this case an interface must be
defined as AutoSelect is not applicable.
Destination Enter a destination IP Address in dotted decimal notation, according to the rules.
Netmask To define the applied network, enter a Netmask in dotted decimal notation, according to the
rules.
NOTE: You
must press
Send Update to
effect any
changes you
make to the
table
.