Operation Manual

SFX SERIES USER’S GUIDE
Rev 2.2 34
Edit Field Description
Supply Select Enables or disables the LNB power supply, which supplies DC voltage to the LNB from the L-
Band connector on the rear panel. When enabled, the DC voltage output will be determined by
the polarization setting from the Carrier Edit <X> page.
AFC Range The AFC range in Hz, in the numeric range 500 to 2000.0 kHz (0.5 to 2 MHz), in steps of 0.1
kHz. The default value in the receiver is +/- 2000kHz. If this field is set to 0 an AFC range of
10% of the carrier symbol rate will be applied. In the event that the resulting range (produced
by 10% of the carrier symbol rate) is too small, adjust the AFC Range manually here.
Channel Guide
When the Channel Guide Main Menu Tool Bar item is selected the Channel Guide main page is displayed. If this
feature is supported by your network a list of the available audio channels will be shown. The list presents additional
information about each audio channel and avoids you having to know specific multicasts addresses and port numbers
for each channel. This electronic channel guide (ECG) is provided and updated by the Service Provider. If there are no
channels available, or the service is not supported, a message will be displayed on this page. If the ECG is not
configured and enabled under Configuration – sub menu - Channel Guide, no channels will be shown here. A sample
channel guide page is shown in Figure 2- 9.
Figure 2- 9 Channel Guide Main Page
The displayed channels are coloured with the following meaning:
Row Colour Description
None The receiver is authorized for this channel, but is not currently playing it.
Green The receiver is currently playing this channel.
Red The receiver is not authorized to receive the PID needed by this channel.
Aside from the Common Menu Items, the following menu items are available:
NOTE:
To obtain the
ECG you must
set up and
enable the
Channel Guide
Configuration –
see under
menu item
Configuration