Operation Manual

SFX SERIES USER’S GUIDE
Rev 2.2 122
Figure D- 1 Removing the Rear Panel Option Plate
When facing the front of the CA Module, where the SC is inserted, you will notice a difference in size (thickness) of the
slot opening (refer to Figure D- 2). Always ensure that the thickest side of the SC opening faces the top. Generally this
is the same side as the service provider’s label.
Figure D- 2 Front View of a CA Module
Referring to Figure D- 3, insert your SC into the CA Module. Ensure that the card is inserted all the way into the CA
Module slot with the gold contacts on the card facing up and pointing towards the CA Module, as shown. Then,
carefully insert the whole assembly into the rear panel CA slot on the receiver. Once the whole assembly has been
inserted, you can close the slot again with the Rear Panel Option Plate.
Remove these 3 Philips screws and
carefully remove the option plate.
Rear Panel
Option Plate
While removing the rear option plate, hold
on to the PCI Slot Back Plate tab, to
ensure that it remains in place. This is not
a problem for a single plain rear option
plate, or if the plate is attached to a PCI
option card.
PCI Slot
Back Plate