Operation Manual

SFX SERIES USER’S GUIDE
Rev 2.2 118
7. You can send a command to force a master receiver into backup state and a backup receiver in the network
should take over for the master receiver. (This might be useful in the case of upgraded receiver firmware).
You can send a command to force the master receiver back to master status as well.
Web GUI Operation
If your receiver has the Redundancy Option enabled, then additional menu items and display pages will be provided.
These are accessed via the Configuration Menu, in a submenu item called Redundancy Configuration. Selecting this
submenu displays the Redundancy Configuration Page, as shown in the example Figure C- 1.
The remaining fields displayed on the Redundancy Configuration Page are described under the Redundancy
Configuration Edit page, Figure C-2.
Figure C- 1 Redundancy Configuration Page
Aside from the Common Menu Items, the following menu items are available:
Menu Item Description
Show Selecting this button will always return you back to the Redundancy Configuration page, as
shown in Figure B-1. The current configuration as entered under the configuration edit page is
always displayed here, along with the current status, which indicates whether or not the
receiver is currently the master or backup device. This value reports as N/A if the receiver is
out of lock or redundancy is disabled.
Edit Selecting this button will enter the Redundancy Configuration Edit page, as shown in Figure B-
2. The edit fields on this page are explained below the page.
Set Master Forces a receiver to achieve master status.
Set Backup Forces a master receiver to achieve backup status.