User manual

• Remove the protective lm from the adhesive strip.

• Press the assembled MAX! Wall Thermostat

with the

back side to the wall in the position where it should sub-

sequently be attached.

Screw mounting:

• Choose a site for installation.

Make sure that electrical lines in the wall will not be

damaged.

• Position the mounting plate on the desired site on the

wall. Make sure that the arrow on the mounting plate is

pointing upwards.

• Use a pen to mark the positions of 2 bore holes A (dia-

gonally opposite) in the mounting plate on the wall. The

bore holes B can be used for installation with a ush-

mounting box.

• If you are working with a stone wall, drill the marked two

5 mm holes and insert the plugs supplied. If you are wor-

king with a wooden wall, you can pre-drill 1.5 mm holes

to make screws easier to insert.