User manual

34
9. Teaching-in of MAX! components
In order to enable communication between MAX! com-
ponents, the devices have to be taught-in to one another.
Once you have taught-in MAX! Radiator Thermostats di-
rectly with the Wall Thermostat, they will adopt the current
settings from it (e.g. mode, temperature, week programme).
The Wall Thermostat will pass on all commands and set-
tings to the taught-in devices in a radial pattern. After
teaching-in the Wall Thermostat with the MAX! LAN-Gate-
wayallcongurationsandchangescanbeconveniently
carried out through the MAX! PC software. The allocation
to the rooms or the distribution of commands and settings
to other devices will occur automatically.
To teach-in your components proceed as follows:
• First switch the teach-in partner, e.g. the MAX!
Cube, to teach-in mode.
• Now enable the teach-in mode on the MAX! Wall
Thermostat by pressing and holding down the OK
button.
• The antenna symboll (
) is displayed, along with
the teach-in time remaining in seconds. The teach-
in time is 30 seconds.
• After teaching-in was successfull, the Wall Ther-
mostat switches into the standard operating mode.
Teach-out can only be performed by factory reset.
When networking with the MAX! LAN Gateway, all
individually programmed settings of the MAX! Wall
Thermostat will be lost.