User Manual

99
Building Your Max-Trainer
1. Install the landing main legs in to the bottom of the fuselage. Place the plastic saddle clamps in
place evenly and pilot drill 4 x 2mm holes for the self tapping screws. Screw M3x10 self tapping screws
through the saddle clamps in to the pilot holes and tighten rmly.
2. It is important to make sure the wheel spins freely on the axle so you may need to sand/le the
axles until the wheel slides on easily. First install one of the collets followed by a wheel and then the nal
collet. Tighten the grub screws to hold the wheel in place making sure the wheel will still spin.