User Manual

77
Building Your Max-Trainer
3. You now need to t your spinner and prop to the engine. Make sure it is tted correctly and is tight,
it is advisable to make sure the prop is balanced before you t it.
4. Assemble the fuel tank. Cut the fuel tube to 60-65mm and t the brass clunk and then gently bend
the vent and pressure tubes as shown in the photo. Push the assemble clunk on to the feed pipe. Fit the
bung assembly in to the tank making sure the vent/pressure pipes are pointing up and the clunk is free
to move around in side the tank and is not being restricted. Tighten the screw and t 3 lengths of pipe
approximately 150mm long to the outlets.
5. Lift the cabin from behind the mount to reveal the fuel tank bay. You can cut a slot into to the fuel
tank bay for your receiver battery to go under the fuel tank. Pack around the battery with foam to hold it in
place.