User Manual

44
Building Your Max-Trainer
1. Take the plywood electric motor mount and drill 4 hole to suit your electric motor after marking and
aligning the motor on the mount. Using 4 x 3mm cap head bolts & washers t the captive nuts to the back
side of the plywood mount by tighten them together. Mix a little epoxy and apply this to the captive nuts to
help hold them in place.
2. Next you need to drill 4 access holes so that you t the motor mount to the front of the model.
These need to be just big enough to get your 4mm allen key through.
3. Now you can secure the assembly to the front bulkhead of the model using the supplied m4x14mm
cap head bolts and washers. Once mounted you can then t your motor. The wires should pass down
under the motor and in to the fuselage and connect to your speed controller.