User Manual

1111
Building Your Max-Trainer
3. When tting the tail and n the covering needs to be removed so the 5minute epoxy can set hard
wood to wood. Slide the tail plane in to place making sure it is aligned and spaced correctly and mark the
position on the lm that needs to be removed using a pen on both the top and bottom. Slide the vertical
n in to place and mark the area of lm that needs to be removed. Using a sharp knife remove the
lm approx 1mm inside of the line, this gives a better nish. Be careful not to cut in to the tail or the n
structure as this will weaken the surface. Do not t yet.