Service manual

Page 4-18 SATO D508/D512 Service Manual

CUTTER ASSEMBLY

The cutter assembly is an optional unit typically preinstalled at the factory. To retrofit a X700

printer that was not originally delivered with a cutter, follow the procedures here but make sure to

order the complete set of components that also includes the cutter alignment assembly that

mounts near the print head.

1 Turn off the printer and disconnect the power supply cord.

2 Open top housing cover (1) and remove front cover (2) from printer base (3).

3 Connect the cutter unit’s wiring harness to the accessory connector.

4 Pivot the dispenser bar (4) upward (Figure 4-12a) to permit cutter assembly (5) installation.

Figure 4-12a, Cutter Installation

5 Apply cutter assembly (5) to the front of printer base (3) and secure using two screws (6).

6 Lower the dispenser bar (4) and apply the front cover (2).

7 Perform steps 7 through 13 to install/replace the cutter blade as the situation requires.

NOTE: If unsure which connector is the accessories connector, refer to the

Introduction unit of this manual for identification.

NOTE: When mantling the cutter unit, ensure the hangers on the back side of

the assembly insert into their respecitve slots on the printer base so as to

suspend the assembly. If this is performed correctly, the two mounting holes

will be properly aligned for the attaching hardware.