Specifications

T-Max® Manager/Pro and T-Max® 3A User’s Guide Page 7
to the modular connector on the T-Max® Mgr/Pro (refer to Figure G, Section 12.7). If you are
using a computer connect the RS-232 DB9F-DB9M cable between the serial port on the T-
Max® Mgr/Pro and the serial port on the back of your computer.
3.3 T-Max® 3A
A T-Max® 3A must be connected to each tanning bed and power must be applied. (Refer to
Section 2.1 and Section 12.2-Figure B).
In the first tanning room, connect the modular cable connected to the T-Max® Mgr/Pro to one
of the modular ports on the back of the T-Max® 3A. Connect the modular cable running to the
next tanning room to the open modular port. In the second tanning room, connect the modular
cable from the first tanning room to one of the modular ports on the back of the T-Max® 3A.
Connect the modular cable running to the third room to the open modular port. Repeat this
until all of the rooms are connected. (Refer to Figure G, Section 12.7 in this manual and
Figure B, Section 12.2).
4 INITIAL CONFIGURATION
4.1 Setting the Address on the T-Max® 3A
Note: If you are installing a new T-Max® system and have just completed Section 2 (Quick
Installation), the addresses on the T-Max® 3As are set and you do not need to independently
set addresses on the T-Max® 3As
1) Remove power from the T-Max® Mgr/Pro.
2) Apply power to the T-Max® 3A. It should show a 9.9 and an alarm should sound.
If it just shows a 0, go to Step 4.
3) Press and release the Start/Stop button. The display will flash an 8.8 and the alarm will
stop. Press and release the Up button until the display stops flashing and shows a 0.
4) Press and hold the Start/Stop and Up Buttons simultaneously on the T-Max® 3A until a .1
appears on the display. This should take about 5-6 seconds. Release the buttons.
5) Press the Start/Stop button on the display. A flashing number will appear. This is the
address that the timer is currently set to.
6) Press the Up or Down button until the desired address is displayed.
Note: When setting the addresses, remember these three rules:
• Set each T-Max® 3A to a unique address.
• Do not set any T-Max® 3A to address 00.
• If the period is flashing, you are over address 100.
7) Once the desired address is displayed, press and release the Start/Stop button. A solid .1 will be
displayed.
8) Press and hold both the Up and Down buttons until a 0 is displayed.
Repeat Steps 2-8 for each T-Max® 3A that you are manually setting the address on.