Specifications
Table Of Contents
- OVERVIEW
- Quick Installation
- INSTALLATION
- INITIAL CONFIGURATION
- MANUAL OPERATION
- COMPUTER OPERATION
- EXPANSION
- T-MAX® 3A OVERVIEW
- IN-ROOM SINGLE BED CONTROL
- REMOTE SINGLE BED CONTROL
- OTHER FEATURES and OPTIONS
- FIGURES
- Figure A - Front View Of The T-Max® 3A
- Figure B - Rear View Of T-Max® 3A Circuit Board
- Figure C - Connecting The T-Max® Sentry™
- Figure D - Connecting To Lower Current Beds
- Figure E - The T-Max® Mgr/Pro
- Figure F - Connecting The T-Max® Series
- Figure G - Multiple Configurations
- Figure H - Modular Cable Pinouts
- Figure I – Connecting An External Push Button to a T-Max® 3A
- TROUBLE SHOOTING
- Index
T-Max® Manager/Pro and T-Max® 3A User’s Guide Page 42
12.8 Figure H - Modular Cable Pinouts
RJ-22 Connector Untwisted Modular Cable RJ-22 Connector
RJ-22 Connector Untwisted Modular Cable RJ-22 Connector
Use this diagram if you are making your own cables
Important!!!
Salon Systems, Inc. highly recommends that you do not modify the cables provided with each T-Max® 3A. If
you need longer cables, contact your dealer or Salon Systems, Inc. All cables are pre-tested at the factory for
proper connection. If you are not careful in making your own cables, the system may not work properly!
Note: If you are making your own cables, you will need a tool for connecting RJ-22 connectors. Call Techni-
Tool @ 1-800-832-4866 and ask for part number 702ST019.
12.9 Figure I – Connecting An External Push Button to a T-Max® 3A
The T-Max® 3A can be ordered with an external push button option. When the button is pushed, a
contact closure is applied to the External Start input on the T-Max® 3A. If the T-Max® 3A is in
delay, the bed will be energized with out having to press the Start/Stop button.
Pushbutton
To external start screw
terminals on back of T-
Max® 3A