Specifications
Table Of Contents
- OVERVIEW
- Quick Installation
- INSTALLATION
- INITIAL CONFIGURATION
- MANUAL OPERATION
- COMPUTER OPERATION
- EXPANSION
- T-MAX® 3A OVERVIEW
- IN-ROOM SINGLE BED CONTROL
- REMOTE SINGLE BED CONTROL
- OTHER FEATURES and OPTIONS
- FIGURES
- Figure A - Front View Of The T-Max® 3A
- Figure B - Rear View Of T-Max® 3A Circuit Board
- Figure C - Connecting The T-Max® Sentry™
- Figure D - Connecting To Lower Current Beds
- Figure E - The T-Max® Mgr/Pro
- Figure F - Connecting The T-Max® Series
- Figure G - Multiple Configurations
- Figure H - Modular Cable Pinouts
- Figure I – Connecting An External Push Button to a T-Max® 3A
- TROUBLE SHOOTING
- Index
T-Max® Manager/Pro and T-Max® 3A User’s Guide Page 39
12.3 Figure C - Connecting The T-Max® Sentry™
Load Carrying Line
from Tanning Bed.
Run the load carrying line from the tanning
bed through the center of the T-Max®
Sentry™ then back to the bed. If you do not
know where this wire on our tanning bed is,
contact the tanning bed manufacturer. For
beds that pull less than 10 AMPS, see Figure
Wires screw into Sensor input D, Section 12.4.
on T-Max® 3A (see Figure B, Section 12.2)
The T-Max® Sentry™
12.4 Figure D - Connecting To Lower Current Beds
For beds that pull less than 10 AMPS, wrap the wire around the T-Max® Sentry™ one time.
The T-Max® Sentry™