Specifications

T-Max® Manager/Pro and T-Max® 3A User’s Guide Page 35
solid period will be displayed on the lower center on the T-Max® 3A. The display and
ADNET will read COOL and the light on the left of the T-Max® Mgr/Pro will flash green.
You cannot start a session until the cool down time has elapsed.
11.2 Cool Down Mode
Cool Down mode is used for beds that require a time to cool down before the next session can
be run. High-pressure beds primarily use this. While the T-Max® 3A is in Cool Down Mode,
a session cannot be run until the cool down time has expired.
To enable Cool Down Mode, set parameter 13 to the time in minutes you want the cool down
time to last. Setting parameter 13 to 0 disables Cool Down Mode. (Refer to Section 5.2.6 if
you are using the T-Max® Mgr/Pro manually, Section 6.3.9 if you are using ADNET, or
Section 8.2 if you want to disable Clean Room at the T-Max® 3A)
After the session ends, the T-Max® 3A will go into Cool Down Mode. A single period will be
displayed on the T-Max® 3A and T-Max® Mgr/Pro will show a flashing green light for the
duration of the cool down time. ADNET and the T-Max® Mgr/Pro display will show Cool
with the time counting down. If clean room is also enabled the clean room will be displayed.
ADNET and the T-Max® Mgr/Pro display will show Dirty and the light for that room will be
solid red , but the Cool Down time will be shown counting down. If the room is cleaned before
the cool down time has elapsed or if the clean room is disabled, a solid period will be
displayed on the lower center on the T-Max® 3A. The T-Max® Mgr/Pro display and ADNET
screen will show Cool with the cool down time counting down. You cannot start a session
until the cool down time has elapsed.
11.3 T-Max® Monitor/Plus
The T-Max® Monitor/Plus allows the salon owner to check the status of all the beds at any
place in the salon.
The T-Max® Monitor/Plus has 16 LED displays showing remaining session time. Multiple T-
Max® Monitor/Plus’ can be connected for large salons. The T-Max® Monitor/Plus can be
connected anywhere in the T-Max® chain. You can connect them at the front desk if you want
to glance over and see remaining session time, or you can place them anywhere else in the
salon so the cleaning staff can see how much session time is remaining for each room. Contact
your dealer for more information.
11.4 T-Max® Sentry™ (Optional)
The T-Max® Sentry™ is a current sensing device that detects when a bed is energized when it
should not be or is not energized when it should be. If you are not using a T-Max® Mgr/Pro ,
the T-Max® 3A must be programmed with this option enabled at the factory. Contact your
dealer for this option.
Note: Remove power from the tanning bed when installing this option. We recommend that a
licensed electrician installs this option.
1) Place the Jumper on Pins 1&2 on JP99 on the back of the T-Max® 3A (See Figure B).