Specifications

T-Max® Manager/Pro and T-Max® 3A User’s Guide Page 34
10.2 Configuration
Set the address on the T-Max® 3A in the tanning room to “1”, and the address on the T-
Max® 3A at the front desk to “0” as described in Section 4.1. Disconnect the modular cables
when setting the addresses on both T-Max® 3As.
Use the Front Desk T-Max® 3A to set the Delay as described in Section 8.2.2. Any delay time
set on the T-Max® 3A in the tanning room will be ignored.
10.3 Session Control
Starting a session
1) Press the Up or Down Button on the T-Max® 3A at the front desk until the session time is
displayed.
2) Press the Start/Stop button on the front desk T-Max® 3A to start the session.
If a delay other than 0 is set, the delay will count down. A period on the lower right
corner of the display will flash rapidly. When the session starts, the period will flash at
once per second rate. If there is no delay entered, the session will start immediately.
Pausing During the Session
To pause the session press the Start/Stop button on the T-Max® 3A in the tanning room. The
flashing period on the lower right corner of the display will stop flashing and stay illuminated.
The session time will continue to count down and reflect the remaining session time. To restart
the session, press the Start/Stop button on the T-Max® 3A in the tanning room. The period
will continue flashing.
Canceling a Session
Press the Start/Stop and Up buttons on the T-Max® 3A at the front desk at the same time.
11 OTHER FEATURES and OPTIONS
11.1 Clean Room
Once the session time has elapsed, the display will show two solid periods only. This is an
indication that the room needs to be cleaned. To clear the clean room indication, press and
hold the Up button on the T-Max® 3A in the tanning room until the two periods disappear and
a “0” appears. To disable the clean room feature, set parameter 9 to a 0 (Refer to Section 5.2.6
if you are using the T-Max® Mgr/Pro manually, Section 6.3.9 if you are using ADNET, or
Section 8.2 if you want to disable Clean Room at the T-Max® 3A).
If the Clean Room and Cool Down Modes are enabled, the clean room will be displayed
ADNET will show Dirty, but the Cool Down time will be shown counting down. If the room is
cleaned before the cool down time has elapsed or if the clean room is disabled, a solid period
will be displayed on the lower center on the T-Max® 3A and On the T-Max® Mgr. The
ADNET screen will show Cool with the cool down time counting down. You cannot start a
session until the cool down time has elapsed.
If the Clean Room and Cool Down Modes are enabled, the clean room will be displayed. If
the room is cleaned before the cool down time has elapsed or if the clean room is disabled, a