Specifications
Table Of Contents
- OVERVIEW
- Quick Installation
- INSTALLATION
- INITIAL CONFIGURATION
- MANUAL OPERATION
- COMPUTER OPERATION
- EXPANSION
- T-MAX® 3A OVERVIEW
- IN-ROOM SINGLE BED CONTROL
- REMOTE SINGLE BED CONTROL
- OTHER FEATURES and OPTIONS
- FIGURES
- Figure A - Front View Of The T-Max® 3A
- Figure B - Rear View Of T-Max® 3A Circuit Board
- Figure C - Connecting The T-Max® Sentry™
- Figure D - Connecting To Lower Current Beds
- Figure E - The T-Max® Mgr/Pro
- Figure F - Connecting The T-Max® Series
- Figure G - Multiple Configurations
- Figure H - Modular Cable Pinouts
- Figure I – Connecting An External Push Button to a T-Max® 3A
- TROUBLE SHOOTING
- Index
T-Max® Manager/Pro and T-Max® 3A User’s Guide Page 33
9 IN-ROOM SINGLE BED CONTROL
9.1 Starting a Session
If you are using a T-Max® Mgr/Pro, and you want to use the T-Max® 3As manually, you
must unplug power from the T-Max® Mgr/Pro then unplug power to the T-Max® 3A then
plug it back in. Power must stay removed from the T-Max® Mgr/Pro while the T-Max® 3A is
being used independently,
1) Press the Up and Down Button on the T-Max® 3A until the session time is displayed. If the
display shows a 0, and you want to count down from the maximum time, press the down
button.
2) Press and release the Start/Stop button to start the session.
If a delay other than 0 is entered, the delay will count down. A period on the lower right
corner of the display will flash rapidly. When the session starts, the period will flash at a
once per second rate.
9.2 Pausing a Session
To pause a session press the Start/Stop button. The flashing period on the lower right corner
of the display will stop flashing. The session time will continue to count down.
To restart the session, press the Start/Stop button on the T-Max® 3A. The period on the lower
right corner of the display will resume flashing.
9.3 Canceling a Session.
To cancel a session, press the Start/Stop button to pause the session then press the Up button.
The display will show a solitary 0.
10 REMOTE SINGLE BED CONTROL
A T-Max® 3A can be used to control another T-Max® 3A. This is ideal for small salons that
are not using a T-Max® Mgr/Pro. Two T-Max® 3As are required for remote single bed
control.
10.1 Wiring
Place one T-Max® 3A in the tanning room and one at the desired remote location. Connect
the 9V @ 200mA power supply to the power in on the back of each T-Max® 3A. Plug each
power supply into a 120VAC outlet (refer to Figure A, Section 12.1). Connect the T-Max®
3A in the tanning room to the tanning bed as described in Section 2.
Run the provided modular cable from the tanning room to the remote T-Max® 3A. Connect
the modular cable to one of the RJ-22 ports on each T-Max® 3A.