Specifications
Table Of Contents
- OVERVIEW
- Quick Installation
- INSTALLATION
- INITIAL CONFIGURATION
- MANUAL OPERATION
- COMPUTER OPERATION
- EXPANSION
- T-MAX® 3A OVERVIEW
- IN-ROOM SINGLE BED CONTROL
- REMOTE SINGLE BED CONTROL
- OTHER FEATURES and OPTIONS
- FIGURES
- Figure A - Front View Of The T-Max® 3A
- Figure B - Rear View Of T-Max® 3A Circuit Board
- Figure C - Connecting The T-Max® Sentry™
- Figure D - Connecting To Lower Current Beds
- Figure E - The T-Max® Mgr/Pro
- Figure F - Connecting The T-Max® Series
- Figure G - Multiple Configurations
- Figure H - Modular Cable Pinouts
- Figure I – Connecting An External Push Button to a T-Max® 3A
- TROUBLE SHOOTING
- Index
T-Max® Manager/Pro and T-Max® 3A User’s Guide Page 30
5) The following message will appear: Enter the Manager Display Mode. Press 0 followed by
the Enter key.
Note: The Delay and Auto Start mode will be over-written by the computer’s software unless
the Auto Start mode is set to 2 (Infinite Delay).
6.5.12 Version
Pressing V displays the ADNET version number, the NETMGR ROM version number, and
NETMGR RAM version number. Press the Enter Key to Clear the window.
V is also used to update the screen after a bed has been added or subtracted. After you press R
to rescan the network to find the current configuration or L to load the MGRPLS1.BIN, press
V to display the software version number. Press the Enter key to clear the window and the new
configuration will be displayed.
7 EXPANSION
7.1 Adding Beds
IMPORTANT: Maximum times for each bed is programmed into the T-Max® 3A at the
factory. When ordering the T-Max® 3As, make sure you have the maximum time for
each bed available.
One T-Max® Mgr/Pro will control up to 64 beds. To add beds, simply purchase one T-Max®
3A for each bed that you add.
Setting the address on each new T-Max® 3A
Refer to Section 4.1 on setting the address on the T-Max® 3A. Make sure the address set on
each additional T-Max® 3A is not the same as a T-Max® 3A you already have.
Setting the max. bed number on the T-Max® Mgr/Pro
If you are using a computer, refer to Section 6.5.11 on setting the Max. Bed Number. If you
are not using a computer, refer to Section 5.2.1.
7.1.1 The ADNET-Repeater™ (optional)
The T-Max® Series will connect up 128 beds. However after about 25 tanning beds, you may
experience communications errors. If this happens, you may need to add a T-Max® Repeater.
The ADNET-Repeater™ connects anywhere in the daisy chain and amplifies the
communications signal down the rest of the line. (See Figure G, Section 12.7)
7.2 Adding T-Max® Manager/Pro’s
T-Max® Series can have up to 8 T-Max® Mgr/Pro’s. A computer can be added to each T-
Max® Mgr/Pro. Refer to Section 3.2 for instructions on connecting a PC to each T-Max®
Mgr/Pro. To add T-Max® Mgr/Pro’s, follow these steps:
1) The side of the T-Max® Manager/Pro has 2 terminator switches. Flip these two switches up
to the OFF positions on each slave T-Max® Mgr/Pro.