Specifications

T-Max® Manager/Pro and T-Max® 3A User’s Guide Page 29
3) A window will appear with the following message: Enter the Timer Number ->. Enter the
timer number (or bed number) followed by the Enter key.
4) The following message will appear: Enter the Parameter# to change ->. Enter the parameter
number to be changed from Table 4 followed by the Enter key
5) The following message will appear: Enter the Data to Send ->. Enter the desired value
followed by the Enter key. If you want to clear a parameter value, such as clearing bulb hours
after you have changed the bulbs in the tanning bed, enter a 0.
6.5.10 Load - Sending FLASH.BIN to T-Max® Mgr/Pro.
1) Press L
2) A window will appear with the following message: Reload NETMGR Program? (y/n)?.
Press Y
The window will read as follows:
Stopping Manager, Sending Stop Command
Sending: FLASH.BIN
Sending -> 256 bytes to <address>
File Sent OK
Starting Manager.
Sending: -> 256 Bytes to <address> will scroll, with different address numbers being
loaded. After the file is sent the T-Max® Mgr/Pro will rescan.
6.5.11 Manual Parameters
After loading MGRPLS1.BIN in the T-Max® Mgr/Pro, the setup parameters inside the T-
Max® Mgr/Pro may reset. Doing the following can reset these parameters:
1) Press X
2) A window will appear with the following message: Enter the Manager Delay Time ->. Enter
your desired delay time, followed by the Enter key.
3) The following message will appear: Enter the Manager Start Mode->. Enter the Auto Start
mode you desire followed by the Enter key.
This value is for every bed in the salon. If you enter a 0, after the delay time expires, the
session time will start but bed will not energize. The screen will show PAUSE with
session time counting down. If a 1 is entered, after the delay time expires, the bed will
energize and the screen will show ON. If the AutoStart mode is Set to a 2, then the T-
Max® Mgr/Pro is set to Infinite Delay. In this mode, the delay set in the T-Max®
Mgr/Pro and the computer will be ignored, the session time will not start and the bed will
not energize until the Start/Stop button is pressed on the T-Max® 3A. The screen will
show DELAY with the session time entered, the session time will not count down until
the Start/Stop button is pressed on the T-Max® 3A.
4) The following message will appear: Enter the Manager Max Bed Number->. Enter a
number that is equal to or higher than the highest address that you have a T-Max® 3A set to,
followed by the Enter key.