Specifications

T-Max® Manager/Pro and T-Max® 3A User’s Guide Page 28
Monitoring Session Counts
Press the S key. Numbers will appear to the right of the screen. These are the session counts
for each timer. Press the S key again and the numbers will disappear.
Clearing Session Counts
Refer to Section 6.5.9 for clearing Session Counts.
6.5.6 Auto - Changing the Session Start After a Delay.
1) Press the A key.
2) A window will appear with the following message:
Existing Mode : 1
Enter 1 for Start after Delay or 0 for PAUSE after delay ->.
Note: This is for every bed in the salon. This setting is not saved to disk. Every time you enter
ADNET, the AutoStart Mode defaults to 1.
If a 1 is entered, the session will start immediately after the delay time has expired. If a 0
is entered, the bed will pause after the delay time has expired, and the customer must
press the Start/Stop button on the T-Max® 3A to turn the bed on. The time for that
session will start immediately after the delay time has expired in either case. If the T-
Max® Mgr/Pro is set to infinite delay, the Auto Start will be ignored (Refer to Section
6.3.11 for setting up Infinite Delay).
6.5.7 Rescan
Rescan allows the T-Max® Mgr/Pro to locate all T-Max® 3As. This is needed if a T-Max®
3A is added or subtracted from the system. Press R to start the rescan.
After the T-Max® Mgr/Pro has rescanned the system, the numbers on screen will not change.
To update the screen, press V. A window with the software version numbers being displayed.
Press Enter key and the window will disappear with the screen updated. Rescan will not
interrupt active sessions. Rescan will have no effect on Slave T-Max® Mgr/Pro’s.
6.5.8 Get Param - Monitoring Parameters.
Get Param allows you to check (without changing) the parameters listed in Table 4
Press G. A window will appear with the following message: Enter the Parameter# to get ->.
Enter a number from Table 4 followed by the Enter key. The right side of the screen will
show the values stored in each T-Max® 3A for the selected parameter.
6.5.9 SeNd Param - Changing Parameters
This function is used to change the parameters in Table 4. If you are using more than one T-
Max® Mgr/Pro, this function is only available on the Master T-Max® Mgr/Pro.
1) Press N
2) A window will appear with the following message: Enter Security Number ->. Refer to the
folded Security Number sheet that was inserted in this manual.