Specifications
Table Of Contents
- OVERVIEW
- Quick Installation
- INSTALLATION
- INITIAL CONFIGURATION
- MANUAL OPERATION
- COMPUTER OPERATION
- EXPANSION
- T-MAX® 3A OVERVIEW
- IN-ROOM SINGLE BED CONTROL
- REMOTE SINGLE BED CONTROL
- OTHER FEATURES and OPTIONS
- FIGURES
- Figure A - Front View Of The T-Max® 3A
- Figure B - Rear View Of T-Max® 3A Circuit Board
- Figure C - Connecting The T-Max® Sentry™
- Figure D - Connecting To Lower Current Beds
- Figure E - The T-Max® Mgr/Pro
- Figure F - Connecting The T-Max® Series
- Figure G - Multiple Configurations
- Figure H - Modular Cable Pinouts
- Figure I – Connecting An External Push Button to a T-Max® 3A
- TROUBLE SHOOTING
- Index
T-Max® Manager/Pro and T-Max® 3A User’s Guide Page 27
6.5.2 Tan - Session Control
Starting a Session
1) Press T
2) A window will appear and read as follows: Enter the Timer Number ->. Enter the timer
number (or bed number) you want to start, followed by the Enter key.
3) The next prompt will read as follows: Enter the Session Time in Minutes ->. Enter the time
you want the tanning session to last, followed by the Enter key.
Note: If the session time entered is longer than the maximum time programmed into the T-
Max® 3A, the session time will default to the maximum time.
If a delay time other than “0” was entered, the Status will read DELAY. A rapidly
flashing period will appear on the T-Max® 3A. The light representing that bed on the T-
Max® Mgr/Pro will go out. The time on the computer screen will be counting down.
Once the session starts, the bed will turn on and the flashing period will slow to a rate of
once per second. The STATUS will read ON.
Canceling a Session
If at any time you want to cancel a session before the session time expires, press T, enter the
bed number, then enter a “0” or “1” for session time.
6.5.3 Bank - Monitoring Beds
When ADNET.EXE is loaded, beds 1 through 16 are displayed on screen. Press B and beds
17 through 32 will be displayed. Continuing to press B will continue to increment beds, 16 at
a time. Pressing the Alt and B keys simultaneously decrements the bed numbers being
displayed, 16 at a time.
6.5.4 Hours - Bulb Hours
Note: If you are using more than one T-Max® Mgr/Pro, this function is only available on the
Master T-Max® Mgr/Pro.
Monitoring Bulb Hours
Note: If you are using more than one T-Max® Mgr/Pro, this function is only available on the
Master T-Max® Mgr/Pro.
1) Press H
On the right side of the screen, bulb hours will be displayed for each bed. Press H again
and the numbers will disappear.
Clearing Bulb Hours
Refer to Section 6.5.9 for clearing Bulb Hours.
6.5.5 Session Counts
Note: If you are using more than one T-Max® Mgr/Pro, this function is only available on the
Master T-Max® Mgr/Pro.