Specifications
Table Of Contents
- OVERVIEW
- Quick Installation
- INSTALLATION
- INITIAL CONFIGURATION
- MANUAL OPERATION
- COMPUTER OPERATION
- EXPANSION
- T-MAX® 3A OVERVIEW
- IN-ROOM SINGLE BED CONTROL
- REMOTE SINGLE BED CONTROL
- OTHER FEATURES and OPTIONS
- FIGURES
- Figure A - Front View Of The T-Max® 3A
- Figure B - Rear View Of T-Max® 3A Circuit Board
- Figure C - Connecting The T-Max® Sentry™
- Figure D - Connecting To Lower Current Beds
- Figure E - The T-Max® Mgr/Pro
- Figure F - Connecting The T-Max® Series
- Figure G - Multiple Configurations
- Figure H - Modular Cable Pinouts
- Figure I – Connecting An External Push Button to a T-Max® 3A
- TROUBLE SHOOTING
- Index
T-Max® Manager/Pro and T-Max® 3A User’s Guide Page 18
Application is the RAM software version inside the T-Max® Mgr/Pro r.
If the boxes below TX and RX do not flash or Firmware version reads 99.99, then there is no
communications between the PC and the T-Max® Mgr/Pro. Make sure the T-Max® Mgr/Pro
is connected to the PC and power is applied to the T-Max® Mgr/Pro. If there is still no
communications, click Close with the left mouse button, click Setup from the ADNET 2000™
window and try another Comm port setting.
Manager Access Window