Specifications

T-Max® Manager/Pro and T-Max® 3A User’s Guide Page 12
3) Press the Enter button (without entering any time).
If the clean room is enabled and the delay time has expired, DIRTY will appear on the display
the Status LED will be Red. Once the clean room has been cleared, the display on the T-
Max® Mgr/Pro will show READY and the Status LED will turn Green.
5.5 Pausing A Session
To pause a session, press the Start/Stop button on the T-Max® 3A at the tanning bed. The
flashing period will stop flashing and stay illuminated. The T-Max® Mgr/Pro display will
show PAUSE on the display.
Note: The session time will continue to count and display will reflect the remaining session
time.
To restart the session, press the Start/Stop button on the T-Max® 3A. The period will
continue flashing and the Status on the T-Max® Mgr/Pro will change to ON.
5.6 Clean Room
Once the session time has elapsed, the display will show two periods with no numbers which
is an indication that the room needs to be cleaned. For a complete description of Clean Room,
refer to Section 11.1.
5.7 Checking Bed Status
To check the status of a bed, glance at the 64 dual colored lights.
Green = Bed is ready for a new session.
Red = Bed needs to be cleaned.
Off = Bed is not available.
Flashing Red = There are less than two minutes left in a session.
Flashing Green = Bed is in the Cool Down Mode.
Yellow = Scanning or Error.
To check time remaining in an active session, press the bed number followed by Enter.
To check the times on all beds, press the Next or Prev (previous) button repeatedly.