User guide

Max Machinery, Inc. 210 Series User Manual © Copyright 2013 Rev. 002Q4 13
Frequency
Single Phase
Wiring
All Other
Models
Mating Cable
Wire Color
Turck
Pin #
Case Ground Case Blue 3
Common Com Black 4
Power 5-26 Vdc V+ Brown 1
Pulse Output Ph A White 2
N/A NC Grey 5
Frequency
Single Phase
* A current sinking device produces an output pulse which is the opposite of a
sourcing device. A positive DC voltage must be applied to the wire running between
PhA and your PLC. When the output is triggered, this voltage will be grounded to
zero volts. Note: use a 5k ohms resistor to limit the current ow in the signal line.
Current Sinking* Wiring
(models 29X-6XX)
All Other Models Mating Cable
Wire Color
Turck
Pin #
Case Ground Case Blue 3
Common Com Black 4
Power 5-26 Vdc V+ Brown 1
Output Phase A Ph A White 2
Output Phase B Ph B Grey 5
Frequency
Quadrature
Turck Connector
21
4
5
3
Electrical Installation - Wiring
Wiring FREQUENCY
The electrical connector versions are pre-wired inside the transmitter and ready to accept a mating cable (available from
the factory). The liquid-tight, NPT models need to be wired during installation as shown in the table below: