Installation Guide

BEFORE OPERATING HOIST
OPERATING CONTROLS
1.Familiarize yourself with all operating controls
of the hoist and with the operation(s) to be performed. Instructions include, the warnings
on the hoist, and the safety and operating instructions portion of this manual.
2. WARNING! TO PREVENT SERIOUS INJURREVENT SERIOUS INJURREVENT SERIOUS
INJURY FROM HOIST FAILURE:
Do not use damaged equipment.
If adjustments or repairs are necessary, or any defects are known, have the problem corrected
before further use.
3. Do not operate a hoist with an out-of-order sign.
4. Only a qualified technician should perform maintenance to the hoist.
5. Do not use the wire rope as a ground for welding. Do not touch a welding electrode to the wire rope.
6. Designate a work area that is clean and well-lit. The work area must not allow access by children or
pets to prevent distraction and injury.
7. Route the power cord along a safe route to reach the work area without creating a tripping hazard or
exposing the power cord to possible damage. The power cord must reach the work area with enough
extra length to allow free movement while working.
8. There must not be objects, such as utility lines, nearby that will present a hazard while working.
9. Inspect the hoist as explained in Frequent Inspection on page 7 after installation but before use.
*This Hoist has a 25% duty cycle. This means that the Hoist may only be run up to 2 minutes 30 seconds
at a time and then it must be allowed to rest for at least 7 minutes 30 seconds off before further use.
[e-mail]
5
1-800-348-5004
Controller
Stop
Bracket
Pulley
Hook
End Hook
Retract Cable
(raise hook)
Extend
C
able
(lower hook)
25% Duty Cycle
2 minutes 30 seconds
in use
followed by
at least 7 minutes
7 minutes,
30 seconds off