Full Product Manual

1. Do not exceed rated capacity.
2. Lock Trailer Jack in vertical position before applying load.
3. Use on flat, level, hard surface capable of supporting load.
4. Wear ANSI-approved safety goggles during use.
5. Prevent trailer wheels from moving using wheel chocks while raising or lowering.
6. Before towing, fully raise trailer jack and secure properly in its horizontal position.
7. Keep out from under jack and tongue when applying and releasing load, or
moving trailer.
8. Inspect before use. Do not use if parts are loose or damaged.
9. Use in accordance with the Department of Transportation (DOT) regulations.
10. Maintain labels and nameplates on the tool. These carry important safety
information. If unreadable or missing, contact for a replacement.
11. Do not use blocks for additional ground clearance.
12. Do not use on round tongue trailer.
13. Apply force to jack vertically only. Side forces will compromise the jack. Lower
trailer tongue height as far as possible before rolling trailer on jack. Roll slowly
on flat, level, hard surfaces only.
14. Do not climb aboard any vehicle supported by jack.
15. This product is not a toy. Keep it out of reach of children.
16. Use caution when using the Trailer Jack to move a trailer without a vehicle.
Losing control of the trailer due to uneven surfaces can lead to property
damage or serious personal injury.
SPECIFICATIONS
SAFETY WARNINGS
Rated Capacity
Height Range
Wheel Diameter
2,000 lbs
14-1/4” to 26-1/4”
6”
[e-mail]
2
1-800-348-5004