Installation Guide
3
IMPORTANT SAFETY INSTRUCTIONS
READ THESE SAFETY INSTRUCTIONS ENTIRELY
Do not attempt to install this lift if you have never been trained on basic automotive lift installation procedures. Never
attempt to lift components without proper lifting tools such as a forklift or crane. Stay clear of any moving parts that can fall
and cause injury.
1. READ ALL INSTRUCTIONS.
2. READ AND UNDERSTAND all safety warning procedures before operating lift.
3. KEEP AREA WELL LIGHTED.
4. WARNING! RISK OF EXPLOSION. This equipment has internal arcing or sparking parts which should not be exposed
to ammable vapors. This machine should not be located in a recessed area or below oor level.
5. KEEP CONTROL HANDLES AND / OR BUTTONS dry, clean and free from grease and oil.
6. CARE MUST BE TAKEN as burns can occur from touching hot parts on the hydraulic unit’s electric motor.
7. DO NOT operate equipment with a damaged power cord or if the equipment has been dropped or damaged until it has
been examined by a qualied service person.
8. DO NOT let the power cord come in contact with hot manifolds or moving fan blades.
9. IF AN EXTENSION CORD IS NECESSARY, a cord with a current rating equal to or more than that of the equipment
should be used. Cords rated for less current than the equipment may overheat. Care should be taken to arrange the
cord so that it will not be tripped over or pulled.
10. ALWAYS UNPLUG EQUIPMENT FROM ELECTRICAL OUTLET WHEN NOT IN USE. Never use the power cord to
pull the power plug from the outlet. Grasp the plug and pull to disconnect.
11. LET EQUIPMENT COOL COMPLETELY BEFORE PUTTING AWAY. Loop power cord loosely around equipment
when storing.
12. TO REDUCE THE RISK OF FIRE, do not operate equipment in the vicinity of open containers of ammable liquids
(i.e., gasoline).
13. ADEQUATE VENTILATION SHOULD BE PROVIDED when working on operating internal combustion engines.
14. KEEP HAIR, LOOSE CLOTHING, FINGERS, AND ALL PARTS OF THE BODY AWAY FROM MOVING PARTS.
15. TO REDUCE THE RISK OF ELECTRIC SHOCK, do not use on wet surfaces or expose to rain.
16. USE ONLY AS DESCRIBED IN THIS MANUAL. Use only manufacturer’s recommended attachments.
17. DO NOT raise vehicle on the lift until installation is completed as instructed in this manual.
18. KEEP HANDS AND FEET CLEAR. Remove hands and feet from any moving parts. Keep feet clear of lift when
lowering. Avoid pinch points.
19. KEEP WORK AREA CLEAN. Cluttered work areas invite injuries.
20. CONSIDER WORK AREA ENVIRONMENT. Do not expose equipment to rain. DO NOT use in damp or wet locations.
Keep area well lighted.