Installation Guide

29
MaxJax Hydraulic Hose Replacement 1 BendPak TSB 69 – 082020
5240 Willis Rd
Theodore, AL USA
Tel: [phone]
maxjax.com
TECHNICAL SERVICE BULLETIN
MODELS: MAXJAX M6 AND M6K
SUBJECT: HYDRAULIC HOSE REPLACEMENT
The purpose of this Technical Service Bulletin is to describe the new Short Hydraulic Hose used for
connecting the Power Unit to the Hydraulic Flow Divider.
The manual describes connecting the Short Hydraulic Hose to the lower left IN Port on the Hydraulic
Flow Divider, as illustrated below; this configuration will
not work with the Hydraulic Flow Divider that
came with your Lift.
What you need to do:
Rotate the Hydraulic Flow Divider so that the side with two Ports (an IN Port and an OUT Port) is on
the
right side, and then connect the new Short Hydraulic Hose to the lower IN Port on the Flow
Divider, as shown below. The other end of the Hose connects to the Pressure Port on the right side of
the Power Unit.