Installation Guide

20
STEP 13
LIFT OPERATION
TO RAISE VEHICLE:
1. Center the vehicle between columns. Adjust vehicle front-to-back so the center
of gravity falls in the middle of the columns.
2. Position lift contact pads at manufacturers recommended lifting points.
3. Before raising vehicle, be sure all personnel are clear of the lift and surrounding
area. Pay careful attention to overhead clearances.
4. Raise lift by pressing raise button on power unit until contact pads make contact
with the underside of vehicle. *
5. Verifty vehicle is secure and arm restraint locks are engaged on all 4 arms.
6. After the vehicle is raised to the desired height, press the lowering handle until
the lift stops evenly on the safety locks. (See gure 25)
7. When raising the lift, always keep a visual line of site on the lift.
TO LOWER VEHICLE:
1. Before lowering vehicle, be sure all personnel are clear of the lift and sur-
rounding area. Insure all tools and equipment have been cleared from under
the lift.
2. Raise the lift o󰀨 of the safety lock by pressing the raise button on the power
unit. Make sure you raise the lift by at least one inch from the lock to allow
adequate clearance.
3. Disengage the safety lock on each column by pulling up the release handle.
(See gure 26)
4. Push the lowering handle on the power unit until the lift has descended
completely and all 4 arm restraint gears are completely released.
5. When lowering the lift pay careful attention that all personnel and objects are
kept clear. Always keep a visual line of site on the lift at all times.
BE SURE TO READ ALL SAFETY TIPS PRIOR TO OPERATING LIFT. FAILURE TO DO SO MAY RESULT IN
SERIOUS INJURY OR DEATH.
WEEKLY MAINTENANCE
• Lubricate all moving parts with a white lithium grease.
• Check all connections, bolts and pins to insure proper mounting.
MONTHLY MAINTENANCE
• Make a visual inspection of all moving parts and check for excessive signs of wear.
• Check condition of lift pads and adapters.
• Check condition of arm restraints. Adjust as necessary.
• Inspect all bolts, pins and anchor bolts.
• Replace all faulty parts before lift is put back into operation.
*NOTE: Refer to ALI Reference Guide for all lift point recommendations and
safety data.