Installation Guide
2
IMPORTANT NOTICE
1. Read this manual thoroughly before installing, operating, or maintaining this lift.
2. This lift is designed for indoor use only, and should not be installed in a pit or depression.
3. The oor on which the lift is to be installed must be 4" (101mm) minimum thickness concrete, with a minimum
compressive strength of 3000 psi (20 MPa) and reinforced with steel bar.
4. The lifts have specic electrical requirements as described in the Installation Instructions section of this manual.
5. This lift has a minimum ceiling height requirement as described in the Installation Instructions section of this manual.
6. Failure by the owner to provide the recommended shelter, mounting surface, electrical supply, and ceiling height could
result in unsatisfactory lift performance, property damage, or personal injury.
7. Do not attempt to install this lift if you have never been trained on basic automotive lift installation procedures. Reference
ANSI/ALI ALIOM requirements for installation and service of automotive lifts.
8. Never attempt to lift components without proper lifting tools such as forklift or cranes. Stay clear of any moving parts
that can fall and cause injury. These instructions must be followed to insure proper installation and operation of your lift.
9. Dannmar Equipment will assume no liability for loss or damage of any kind, expressed or implied resulting from improper
installation or use of this product.
10. This lift is rated to 6,000-lbs lifting capacity. NEVER EXCEED rated lifting capacity of lift.
11. Qualied person must be consulted for seismic loads and other local or state requirements.
DEFINITIONS OF HAZARD LEVELS
Identify the hazard levels used in this manual with the following denitions and signal words.
Hazards or unsafe practices which could result in severe personal injury or death.
Hazards or unsafe practices which may result in minor personal injury, product or property damage.
Hazards or unsafe practices which may result in minor personal injury, product or property damage.
Lubricate all plastic guide blocks, bearings, and shafts with grease prior to operating the lift. Lubricate all on a weekly basis.
Motors and all electrical components are not sealed against the weather and moisture. Install this lift in a protected indoor
location. Failure by the owner to provide the recommended shelter could result in unsatisfactory lift performance, property
damage, personal injury, and may void the warranty.
BE SAFE: YOUR NEW LIFT WAS DESIGNED AND BUILT WITH SAFETY IN MIND. HOWEVER, YOUR OVERALL
SAFETY CAN BE INCREASED WITH PROPER TRAINING AND THOUGHTFUL OPERATION ON THE PART OF THE
OPERATOR. DO NOT OPERATE OR REPAIR THIS EQUIPMENT WITHOUT READING THIS MANUAL AND THE
IMPORTANT SAFETY INSTRUCTIONS SHOWN INSIDE. KEEP THIS OPERATION MANUAL NEAR THE LIFT AT ALL
TIMES. MAKE SURE THAT ALL USERS READ AND UNDERSTAND THIS MANUAL.