Installation Guide
19
LIFT OPERATION SAFETY
• NEVER exceed rated capacity of 6,000-lbs.
• Tighten all anchor bolts prior to operation. If anchor
bolts are loose, or any component of the lift is
defective, do not use lift.
• DO NOT remove or disable arm restraints.
• DO NOT block, open or override self-closing lift
controls; they are designed to return to the “O” or
Neutral position when released.
• ALWAYS inspect all quick connect/disconnect hose
ends before any attempt is made to raise vehicle.
• ALWAYS be sure to have proper overhead
clearance.
• ALWAYS load vehicle on lift carefully. Position
the contact pads according to the vehicle
manufacturer’s recommended lift points. Raise lift
until lift pads contact vehicle. Check pads for secure
contact with the vehicle.
NOTE:
Refer to ALI Quick Reference Guide for all point
recommendations, dangers and safety data.
• ALWAYS remain clear of lift when raising or
lowering vehicles.
• Do NOT use lift if an unlevel lifting condition occurs
that is greater 3.5" (89 mm).
• DO NOT rock the vehicle or remove heavy
components while on the lift that may alter weight
distribution
• ALWAYS ensure Safety Locks are engaged before
any attempt is made to work on or near vehicle.
• NEVER go under raised vehicle if Safety Locks are
not engaged.
WHEN LOWERING THE LIFT PAY CAREFUL
ATTENTION THAT ALL PERSONNEL AND OBJECTS
ARE KEPT CLEAR. ALWAYS KEEP A VISUAL LINE
OF SITE ON THE LIFT AT ALL TIMES. ALWAYS
MAKE SURE THAT ALL LOCKS ARE DISENGAGED.
IF ONE OF THE LOCKS INADVERTENTLY LOCKS
UPON DESCENT THE VEHICLE MAY DISMOUNT
CAUSING PERSONAL INJURY OR DEATH.
• ALWAYS remove tool trays, stands, etc. before
lowering lift.
• ALWAYS release safety locks before attempting to
lower lift.
• ALWAYS move the lift arms to provide an
unobstructed exit before removing vehicle from lift
area.
• NEVER drive over the lift arms.
VISUALLY CONFIRM THAT ALL SAFETY LOCKS
ARE ENGAGED BEFORE ENTERING WORK
AREA. SUSPENSION COMPONENTS USED ON
THIS LIFT ARE INTENDED TO RAISE AND LOWER
LIFT ONLY AND ARE NOT MEANT TO BE LOAD
HOLDING DEVICES. REMAIN CLEAR OF
ELEVATED LIFT UNLESS VISUAL CONFIRMATION
IS MADE THAT SAFETY LOCKS ARE FULLY
ENGAGED AND THE LIFT IS LOWERED ONTO
THE SAFETY LOCKS, REFER TO OPERATION
MANUAL FOR PROPER SAFETY LOCK
PROCEDURES AND/OR FURTHER INSTRUTIONS.
POST INSTALLATION CHECK OFF
Columns are properly leveled
Anchor bolts are tightened
Electric power supply conrmed
Check for hydraulic leaks
Check oil level
Lubrication of critical components
Check for overhead obstructions
Lift arms are level
Arm restraints properly adjusted
All screws, bolts, and pins are secured
Surrounding area is clear
Operation, maintenance and safety manuals on site