User manual

Preliminary MAVIX
- 48 -
The Graphic Editor Window includes the following areas:
Site:
Allows the user to select the bitmaps to be used as a background.
Device:
Allows the user to add surveillance components to the site, allocate an icon to it, and
position it on the map by using the “Locate” command and clicking on the required
point on the map. (As already mentioned, the components should be defined by the
System Configurator, and the console user should have an access right to those
components). Camera devices may be positioned only on sites, Monitor devices may
be located only in control centers. All other devices (RS232, Microphone, Speaker,
Relay) may be positioned on either locations.
Alarms Graphic:
Allows the user to select alarms, from those defined by the Configurator, and
position them on any spot on the site map by selecting the “Line” or “Square”
commands, and clicking in the required location. The behavior of the system in
response to a triggered alarm is described in the Event Setup section.
Joystick:
When a Joystick is attached to the workstation, This command allows the user to
position a Joystick (if present) by pressing the Locate command., and clicking the
required point on the map.
Manual Recording Parameters:
This box allows the user to define the recording parameters, length and frame rate,
and the location of the recorded video clips, when selecting the “Start Recording”
command, as described above.