Operation Manual

10
10.6. Odometers set up
10.6.1. Enter the
Odometers set up menu:
From any active display, press
and hold the right button
(BPR) for
6 seconds.
– On Wintech USB Ultimate,
briey press the left button
(BPL) 5 times to move to
the odometer section. “odo”
appears on the screen.
– On Wintech USB Alti and
Wintech USB HR, briey
press the left button (BPL)
4 times to move to the
odometer section. “odo”
appears on the screen.
– On Wintech USB, briey
press the left button (BPL)
3 times to move to the
odometer section. “odo”
appears on the screen.
Briey press the right button
(BPR) to start the odometers
settings operations. The bike
number ashes.
10.6.2. Select the bike
number you wish to adjust
the odometer for.
Briey press the left button
(BPL) to select the bike
number you wish to adjust the
odometer for.
Briey press the right button
(BPR) to validate the bike
number selection and switch
to the odometer set up
screen.
10.6.3. Adjust the odometer for the selected bike.
Briey press the left button (BPL) to adjust the rst digit.
Briey press the right button (BPR) to validate your choice and move to the next digit.
Repeat those steps to the 5
th
odometer digit. Validating the 5
th
odometer digit by a brief press on
the right button (BPR) will exit the set up menu and switch back to the last active screen.
To set up the odometer for a 2
nd
bike sensor or the home trainer sensor, proceed again to the
operations described above, selecting the correct bike number.
USE
11. SLEEP MODE
When no speed, cadence and heart rate signals is detected and none of the buttons are
pressed for 15 minutes, then the computer automatically switches to sleep mode, to save the
battery.
Your Wintech computer does not wake up automatically when riding.
Press any of the 2 buttons to wake the computer up.
The last active display will be displayed.
When the computer wakes up, the
BK displays starts to ash. It means
that the computer is looking for the
speed sensor signals. When a signal
is recognized, the BK displays stops
ashing and is completed by the bike
number of the recognized sensor (1,2
or HT). The displayed data automatically
switch to the corresponding sensor.
6 sec.
5 click (Ultimate)
4 click (Alti, HR)
3 click (USB)
1 click
1 click
1 click
1 click 1 click
1 click 1 click
any
screen
select
select
select select
select select
or
auto
10.6.1
10.6.2 10.6.3
11
EXIT