Users Manual

NANO POWER

Digital Radio

Commercial in Confidence

General

The N2 system components are designed for maximum safety and reliability when they are installed, used, and maintained by trained

and qualified technicians in accordance with the procedures and instructions contained in this manual. To ensure the safe operation of

your system, always follow the safety and operational recommendations in this manual.

Warnings

⚫ N2 system is not a consumer product. Please install and use N2 system in accordance with the instructions.

⚫ Before installing or modifying any N2 system equipment, read and fully understand the entire instructions in this guide.

⚫ Only qualified personnel are authorized to install and maintain the N2 system.

⚫ Changes or modifications to the N2 system equipment not expressly approved by the manufacturer could void the product

warranty and the user’s authority to operate the equipment.

⚫ Follow Electro Static Discharge precautions to avoid any damage to PCB, PSU, etc.

⚫ Keep equipment powered-off during installing or modifying.

⚫ Low path loss cables connected to antennas are highly recommended.

⚫ This is NOT a CONSUMER device. It is designed for installation by FCC LICENSEES and QUALIFIED INSTALLERS. You

MUST have an FCC LICENSE or express consent of an FCC License to operate this device. Unauthorized use may result in

significant forfeiture penalties, including penalties in excess of $100,000 for each continuing violation.

⚫ This is NOT a CONSUMER device. It is designed for installation by an installer approved by an ISED licensee. You MUST

have an ISED LICENCE or the express consent of an ISED licensee to operate this device.

⚫ To comply with FCC RF exposure compliance requirements, each individual antenna used for this transmitter must be installed

to provide a separation distance greater than 20cm or more from all persons during normal operation and must not be co-located

with any other antenna for meeting RF exposure requirements.

⚫ To comply with RSS-102 RF exposure compliance requirements, each individual antenna used for this transmitter must be

installed to provide a separation distance greater than 20cm or more from all persons during normal operation and must not be

co-located with any other antenna for meeting RF exposure requirements.

⚫ Antenna gain should not exceed 4 dBi.

Note: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device

may not cause harmful interference, and (2) this device must accept any interference received, including interference that may

cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: