User's Manual

MID POWER

37dBm Octa Band

Digital Radio

Commercial in Confidence

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

Note: Only authorized person can enter the area where the antenna is installed. And the person is fully aware of the potential for

exposure and can exercise control over his or her exposure by leaving the area or by some other appropriate means. Awareness of

the potential for RF exposure in a workplace or similar environment can be provided through specific training as part of a RF safety

program

NOTE: This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two

conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that

may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est

autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit

accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Site Considerations

⚫ M2RU complies with FCC RF exposure limits for an uncontrolled environment.

⚫ The system delay should be taken into consideration when there are neighboring BTS sites with overlapping in coverage.

⚫ Pick an ideal easy-to-reach location for installation convenience.

⚫ Verify that there is a minimum of a 50cm radius of space around M2RU system equipment for the convenience of maintenance

and on-site inspection.

Environmental

Humidity and temperature have adverse efforts on the reliability of the M2RU system. Therefore, it is highly recommended to install

the equipment in locations with stable humidity, temperature, and ventilating.

The equipment has to operate within the following humidity level and temperature range:

Maximum humidity: 100%

Temperature range: -40 to 55℃