Installation Instructions
Table Of Contents
- nanoLTE E61 AP Hardware Installation
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 3 nanoLTE E61 AP Commissioning
- 3.1 Requirements for Commissioning with the Web Page
- 3.2 Redirector First Contact and NTP Synchronisation for Software Update
- 3.3 Configure a Commissioning Terminal
- 3.4 Access the Commissioning Web Page for the LTE AP
- 3.5 Optional - Software Download
- 3.6 Configure the Connection to the NOS Server
- 3.7 Commissioning Complete
- 4 nanoLTE E61 AP Hardware Installation
- 5 Troubleshooting
- 6 AP and PSU Regulatory Information
nanoLTE E61 AP Hardware Installation AP and PSU Regulatory Information
NANO_INST_43325 v205_0.6 for N4G_2.5 © ip.access Limited 2019 Page 34
6.3 Regulatory Statements for the E61 AP
6.3.1 US FCC Compliance
• FCC CFR47 Parts 15B, 2, 96
Note: Changes or modifications not expressly approved by the party responsible for compliance
may void the user's authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
6.3.2 Safety Standards
The E61 unit has passed safety testing in accordance with IEC/UL 62368-1.
6.3.3 Environmental Standards
• Type: Indoor
• Storage: Weather Protected, Partly Temperature controlled Class 1.1 - ETSI
300-019-1-1
• Transport: Public Transport Class 2.3 - ETSI 300-019-1-2
• Operation: Partly Temperature controlled locations Class 3.2 - ETSI
300-019-1-3
Model LTE Band FCC ID
nanoLTE E61 AP Model 495X 48 (CBRS) QGGIPA495X
WARNING
This is a class B product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.