Installation Instructions

nanoLTE E61 AP Hardware Installation AP and PSU Regulatory Information
NANO_INST_43325 v205_0.6 for N4G_2.5 © ip.access Limited 2019 Page 33
6.2 Warnings and Cautions - Optional Power Supply Unit
This section is only applicable when the optional power supply unit (PSU) is supplied with
the E61 AP.
Electrical Safety
Other Warnings and Cautions
WARNING
Do not immerse any part of the power supply in water or any other liquid. Do not install
or use the power supply near open water. Do not spill liquids of any type on the power
supply.
WARNING
Do not use liquid, solvent or aerosol cleaning agents on or near the power supply.
CAUTION
To avoid the risk of fire and/or electrical shock, do not push objects through openings
into the power supply.
CAUTION
Do not disassemble the power supply.
CAUTION
Before using the power supply, verify that the mains voltage is within the range
specified by the voltage printed on the power supply.
CAUTION
When supplied, the PSU supplied with the AP must not be used for powering any
other equipment.
CAUTION
To avoid the risk of fire and/or electrical shock, do not overload power outlets or
extension cables.
CAUTION
When disconnecting the power supply from the mains, pull the plug. Pulling the cable
may result in damage to the cable.
WARNING
Do not install the power supply in a position where the cable may cause a tripping or
choking hazard.
WARNING
Do not install the power supply on an unstable surface. All caution must be observed
to prevent the device from falling and causing injury to a person and/or damage to the
device.
WARNING
The power supply should not be disposed of in household waste bins. Please follow
local regulations for disposal of electronic devices.
CAUTION
Do not install the power supply in a position where the cable may be damaged by
walking on the cable.