Installation Instructions
Table Of Contents
- nanoLTE E61 AP Hardware Installation
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 3 nanoLTE E61 AP Commissioning
- 3.1 Requirements for Commissioning with the Web Page
- 3.2 Redirector First Contact and NTP Synchronisation for Software Update
- 3.3 Configure a Commissioning Terminal
- 3.4 Access the Commissioning Web Page for the LTE AP
- 3.5 Optional - Software Download
- 3.6 Configure the Connection to the NOS Server
- 3.7 Commissioning Complete
- 4 nanoLTE E61 AP Hardware Installation
- 5 Troubleshooting
- 6 AP and PSU Regulatory Information
nanoLTE E61 AP Hardware Installation AP and PSU Regulatory Information
NANO_INST_43325 v205_0.6 for N4G_2.5 © ip.access Limited 2019 Page 32
Other Warnings and Cautions
CAUTION
If using a hearing aid, RF devices may cause interference.
CAUTION
Unshielded electronic devices should not be used near the AP. Conversely, the AP
should not be installed adjacent to unshielded electrical or electronic devices (such as
unshielded speakers).
WARNING
Do not install the AP in a position where any connected cables may cause a tripping or
choking hazard.
WARNING
Do not install the AP on an unstable surface. All caution must be observed to prevent
the device from falling and causing injury to a person and/or damage to the device.
WARNING
The AP should not be disposed of in household waste bins. Please follow local
regulations for disposal of electronic devices.
CAUTION
Do not install the AP in a position where any connected cables may be damaged by
walking on the cables.